MotoTech 10W-30 API Service SN ILSAC GF-5
Distributed by The Kroger Co., Cincinnati, OH
Purchased in: Turkey Hill, Lemoyne, PA
Date of purchase: 3/17/2011
The results of the tests conducted on this sample meet the requirements of an API SN, ILSAC GF-5, SAE 10W-30 Engine oil.
PETROLEUM QUALITY INSTITUTE OF AMERICA
| The ranges and averages shown in the table below are for
current specifications (API SN GF-5)
|TBN, mg KOH/g, (ASTM D2896)||6.1 to 8.3||7.2||8.4|
|Viscosity @ 100ºC, cSt, (ASTM D445)||9.3 to 12.5||10.5||10.7|
|Viscosity @ 40ºC, cSt, ASTM D445||55.8 to 65.2||61.88||66.8|
|Viscosity Index (ASTM D2270)||156 to 169||160||150|
|Viscosity @ -25ºC mPa s (cP) (ASTM D5293)||7,000 Max||5,775||4,184|
|Volatility, mass % loss, 1 hr, @ 250ºC (ASTM D5800)||15 Max||14.2||12.6|
|Nitrogen μg/g (ASTM D-5762)||599 to 990||804.2||737.7|
|Calcium||1,570 to 2,460||2,051||2,355|
|Magnesium, ppm||6 to 46||12.3||10|
|Phosphorus, ppm||600 to 800||703||717|
|Zinc, ppm||766 to 868||791||854|
|Molybdenum, ppm||<1 to 269||60||44|
|Boron, ppm||<1 to 237||79||3|
|Silicon, ppm-d||3 to 9||5||4|
|Potassium, ppm||9 to 17||11||15|
|Titanium, ppm||<1 to 114||11||<1|
|Sulfur, ppm||5,000 max||2,785||3,496|
|Sodium, ppm||5 to 454||172||5|
|Aluminum, ppm||<1 to 3||1||1|
|Iron, ppm||<1 to 1||1||<1|
b- Standards, shown in yellow are established by API, SAE and others. Ranges, shown in teal, represent the high and low data for the 13 major brands of API SN ILSAC GF-5 tested in September 2011.
c-Test Method for metal analysis is ASTM ASTM D5185.
d- Although silicon is used as an antifoam additive in lubricants, concentrations above 7ppm have been linked to contamination from abrasive material,
e- Average of the 13 major brands of API SN ILSAC GF-5 tested in September 2011.
|MotoTech SAE 10W-30 API Service SN|
forth a number
and engine tests
required to meet
an API SN ILSAC
alone cannot be
establish if an
engine oil meets
API SN, they can
be used to
determine if it
The following is a comparison of the test results for the sample of MotoTech 10W-30 tested with the API SN ILSAC GF-5 requirements.
The viscometrics meet the required targets for a 10W-30.
|FRONT AND BACK LABELS FROM PRODUCT TESTED|